Colloidal silver filtering kit instructions Code 5156
(beakers NOT included)
Please note this filtering kit is only designed to remove the large particulate matter that comes off the electrodes.
The kit contains a tube, a filter stone and syringe.
You should use the kit as a basic siphoning system.
BEFORE USING THE FILTERING SYSTEM ON COLLOIDAL SILVER YOU SHOULD CLEAN IT BY RUNNING SOME PURIFIED WATER (OR DISTILLED WATER) THROUGH IT FIRST.
1. Connect the air stone to the tube and put the air stone into your CS Solution and make sure it goes to the bottom of the container. Stick the tube to the side of the container with some tape to stop the tube being pulled out of the solution. This container needs to be at least 40cm above the container into which you are going to siphon your Colloidal silver.
2. Connect the syringe to the other end of the tube. (It is a fairly loose fit so push the end of the syringe all the way into the tube). Pull the syringe plunger partly out to start the siphon of your Colloidal Silver. Fold the tube over to stop the flow and remove the syringe. Then fill your container(s), again folding the tube over to stop the flow as required.
3. To clean the stone simply put the stone on the lower end of the siphon tube and flush through with purified water.
