This product is made in the UK for GoodVitality by Commercial Science (www.comsci.org.uk) and contains a special computer chip programmed to carry out the functions of this fully automated Clark's Zapper.
The treatment cycle is timed and automatically taken care of by our customised computer chip.
When switched on the ACZ1 14 volt Zapper will automatically go through the following steps:
- Auto diagnostic test = lights all the lamps and bleeps to let you know everything works.
- One second later the computer chip analyses the battery. If it fails the test the red lamp is illuminated and the unit beeps to tell you to change the battery.
- There will be three warning beeps to tell you to pick up the electrodes. The yellow lamp comes on continually while you Zap for 7 minutes.
- A long beep sounds to tell you the Zapping cycle is over. The yellow lamp now flashes for the 21 minute wait period.
- Repeat of stage 3.
- Repeat of stage 4.
- Repeat of stage 3.
- Your Zapping is completed. The yellow lamp goes off completely and the Zapper beeps at you periodically to remind you to turn the unit off.
The unit incorporates a battery failure protection system. The microcontroller tests the battery before Zapping can commence, if the battery level is low the red lamp comes on and Zapping will not begin.
1 X 9 volt PP3 batteries included.
Hand Held Probes. NOW MADE OF COPPER. Please note you can also use BIOTABS with the Clark's Zapper.
This device meets the design criteria as defined in Dr Hulda Clark’s book "A cure for all diseases".
The principle behind Clark’s Zapper is resonance. Theoretically by exposing a micro organism to its resonant frequency you will make it burst. What is resonance? A good example is a wine glass, when you rub your finger around the edge it resonates, by playing this sound back to the wine glass with a powerful sound system you will make it shatter. This principle was discovered by Hulda Clark herself who claims it will kill bacteria, mould, yeast and parasites.
Order will include:-
Clarks Zapper 14volt Automatic (timed), 1 9v PP3 battery, 2 copper electrodes and a set of instructions.
